Well Pressure Tank Installation | The Home Depot
Well Pressure Tank Installation | The Home Depot
Well Pressure Tank Installation | The Home Depot
[MUSIC PLAYING] On the occasion that you require to
replace your pressure storage tank, I have a container here that we'' ve
obtained from Home Depot that prepares to go. We put a 10 inch tank tee in the unit. Therefore I'' ve currently put Teflon tape on every one of my fittings, but I wanted to make sure I explained exactly how every one enters into the container tee. This is a drain shutoff. It'' s going to string directly into this line. As well as again, the Teflon tape will certainly be able to hold everything together and also maintain a good, tight seal. Then, we have a stress safety valve. This allows the stress, in case the pressure obtains expensive in the container, that this will in fact open up up as well as stop any concerns. So we'' re going to thread that therein. The next device is a stress gauge.The pressure scale will certainly permit us to understand what the stress goes to this storage tank. You have a stress gauge on the pump, but additionally, you'' ll have a second one that ' s going to be threaded right into this storage tank tee. And this will allow us to recognize what pressure it goes to the storage tank factor. And the last thing we have is a little 1/4 inch plug. This plug below is to [relieve?] stress into the system. And we'' re going
to throw that in, too. Currently, this is the container setting up. It'' s prepared to be placed in with the system. All we'' re going to do is we have a 1 inch women line. The 1 inch female line is mosting likely to most likely to the outward bound line to the home. And then, we'' re mosting likely to have a 1 inch female entering into this side, which is going to go in the direction of the pump. Since the container assembly is finished, we need to make sure that we check the pressure. This tank must have a cut-in pressure at around 28 PSI.The reason that is since we put in a jet pump that has a 30 to 50 PSI pressure button, and it requires to be 2 PSI below the 30 PSI. So 28 PSI is our cut-in. And you merely just eliminate this plug here, make use of a routine tire scale to examine the stress. And also if it'' s at 28 PSI, you ' re great. If not, you can either soothe air or you can include air by taking a pump and simply pumping right into this.Once you ' ve done that as well as'the unit ' s. at 28 PSI, you can place
the cap back on. And also the tank ' s prepared to perform.'[ MUSIC PLAYING]
Well Pressure Tank Installation | The Home Depot
Well Pressure Tank Installation | The Home Depot
Well Pressure Tank Installation | The Home Depot
Well Pressure Tank Installation | The Home Depot